The replacement of incandescent projector is too frequent an event for those who want a home theater projector has owned for a long time. In the course of a lifetime of 2000 hours, as a lifetime for some people, sounds, confident that not long before the projector lamp must be replaced. However, there are some general tips to help prolong the life of a projector for the projection unit.
Do not touch the bulb with bare hands
One of the most common problemsmet people replacing the bulbs with their bare hands. While this is normal for a light bulb in order, not a good exercise for a projector lamp. The lamp in a projection unit burns much hotter than a standard bulb. The effects of contact with bare skin are magnified and problematic.
Touching a projector bulb with bare skin leaves traces of oil on the surface of the lamp. Although this seems to be a very small detail, is disadvantageous for both the bulb and theResulting multimedia display quality. The oils have the lamp burned, and drastically reduce the life span. Because the oil is boiled to the surface, it spreads the light is actually projected, which actually sent the light reflective surface. The light is not sufficient to correct the image that comes out of the home theater projection system is planned for the project. While the problem may not be obvious at first, for a while 'time, the qualityDegradation is not visible to the point.
Turn off the projector after the lamp is turned
It is strongly recommended to power the projector turned "off" position after turning off the lamp and permit allows. So fans can go to work were designed to have done. While conducting a rapid cooling and heating repeated contractions and expansions of the filament, it is much better that it be done faster with the coolingFans. Similarly, the projector and allow the fans for a moment before turning on the lamp also help run. This will add hours of lamp life expectancy and therefore for more hours of viewing pleasure on the home theater projection system.
Constant movement
Constantly pushing or moving the projector, especially while it's hot can be very damaging to the projector lamp. The filament of the bulb loses almost all of the tensile strength, if during the heatingnormal use. And 'much like the filament in a lamp field. The principle is the same, the filament is in fact almost the same consistency as the ash, which makes it extremely vulnerable to damage when it is hot. After sufficient cooling the lamp filament is very sensitive. Be careful when transporting the projector for some reason. While it is always a good idea to be careful with electronic equipment, some aspects of the projector at home actually a little 'moresensitive.
It is usually necessary to move the projector during cleaning of the filter. As always, it's a good idea to move it gently, without jerking around, or no longer meet, if necessary. Under moment or two to control the projector and check that it can still be securely fastened to avoid earnings and slipping and movement, which can otherwise be harmful.
With a little 'bit of attention and a' preventive maintenance, the projector lampsbe changed, but not as often.
No comments:
Post a Comment